Vacuum

For other uses, see vacuum cleaner and Vacuum (musical group).

Creating a vacuum

The easiest way to create an artificial vacuum is to expand the volume of a container. For example, your muscles expand your lungs to create a partial vacuum inside them, and air rushes in to fill the vacuum. By repeatedly closing off a compartment of the vacuum and exhausting it, it is possible to pump air out of a chamber of fixed size in a manner analogous to pumping a milkshake out of a glass. This is the principle behind most mechanical vacuum pumps. Inside the pump, a mechanism expands a small sealed cavity to create a deep vacuum. Because of the pressure differential, some air from the chamber is pushed into the pump's small cavity. The pump's cavity is then sealed from the chamber, opened to the atmosphere, and squeezed back to a minute size.

Related Topics:
Milkshake - Glass - Vacuum pump

~ ~ ~ ~ ~ ~ ~ ~ ~ ~

A mechanical vacuum pump moves the same volume of gas with each cycle, but as the chamber's pressure drops, this volume contains less and less mass. So although the pumping speed remains constant when measured in litres/second, it drops exponentially when measured in kilograms/second. Meanwhile, the leakage rates, evaporation rates, and sublimation rates produce a constant mass flow into the system. When the pump's mass flow drops to the same level as the mass flows into the chamber, the system asymptotically approaches a constant pressure called the base pressure. Evaporation and sublimation into a vacuum is called outgassing, and the most common source is water absorbed by materials in the chamber. Outgassing can be reduced by desiccation prior to vacuum pumping. The base pressure of a rubber- and plastic-sealed piston pump system is typically 1 to 50 kPa, while a scroll pump might reach 10 Pa and a rotary vane oil pump with a clean and empty metallic chamber can easily achieve 0.1 Pa.

Related Topics:
Volume - Pressure - Mass flow - Evaporation - Sublimation - Outgassing - Desiccation - Rubber- - Plastic

~ ~ ~ ~ ~ ~ ~ ~ ~ ~

If the dominant mass flow into the vacuum system is chamber leakage or outgassing of materials under vacuum, then the vacuum can be improved simply by installing bigger pumps. However, there is a point where backstream leakage through the pump and outgassing of the pump oils become the dominant mass flows into the chamber. In this situation, the vacuum will approach the pump's ultimate pressure - the best vacuum that this type of pump can achieve under ideal conditions. Adding more pumps in parallel or bigger pumps of the same type can still improve the pump-down speed, but they will not reduce the base pressure below ultimate. Better pumping technologies must be used to go beyond this barrier.

~ ~ ~ ~ ~ ~ ~ ~ ~ ~