Altair 8800

The MITS Altair 8800 was a microcomputer design from 1975, based on the Intel 8080A CPU. Sold as a kit through Popular Electronics magazine, the designers intended to sell only a few hundred to hobbyists, and were surprised when they sold over ten times that many in the first month. Today the Altair is widely recognized as the spark that led to the personal computer revolution of the next few years: The computer bus designed for the Altair was to become a de facto standard in form of the S-100 bus, and the first programming language for the machine was Microsoft's founding product, Altair BASIC.

Description

In the first design of the Altair, the parts needed to make a complete machine would not fit on a single motherboard, and the machine consisted of four boards stacked on top of each other with stand-offs. Another problem facing Roberts was that the parts needed to make a truly useful computer weren't available, or wouldn't be designed in time for the January launch date. So during the construction of the second model, he decided to build most of the machine on removable cards, reducing the motherboard to nothing more than an interconnect between the cards, a backplane. The basic machine consisted of five cards, including the CPU on one and memory on another. He then looked for a cheap source of connectors, and came across a supply of 100-pin edge connectors. The rest, as they say, is history, and the S-100 bus was eventually acknowledged by the professional computer community and adopted as the IEEE-696 computer bus standard.

Related Topics:
Motherboard - Backplane - CPU - Edge connector - IEEE-696

~ ~ ~ ~ ~ ~ ~ ~ ~ ~

For all intents, the Altair bus consists of the pins of the Intel 8080 run out onto the backplane. No particular level of thought went into the design, which led to such disasters as various power lines of differing voltages being located next to each other, leading to easy shorting. Another oddity was that the system included two unidirectional 8-bit data buses, but only a single bidirectional 16-bit address bus. A deal on power supplies led to the use of +8V and +18V, which had to be "pulled down" on the cards to TTL (+5V) or RS-232 (+12V) standard voltage levels.

Related Topics:
Altair bus - Intel 8080 - 8-bit - V - TTL - RS-232

~ ~ ~ ~ ~ ~ ~ ~ ~ ~

The Altair shipped in a two-piece case. The backplane and power supply were mounted on a base plate, along with the front and rear of the box. The "lid" was shaped like a C, forming the top, left and right sides of the box. The face plate, reportedly inspired by the Data General Nova minicomputer, included a number of large toggle switches to feed binary data directly into the memory of the machine, and a number of red LEDs to read those values back out.

Related Topics:
Data General Nova - Toggle switch - Binary - LED

~ ~ ~ ~ ~ ~ ~ ~ ~ ~

Programming the Altair was an extremely tedious process where one toggled the switches to positions corresponding to an 8080 opcode, then used a special switch to enter the code into the machine's memory, and then repeated this step until all the opcodes of a presumably complete and correct program was in place. When the machine first shipped the switches and lights were the only interface, and all one could do with the machine was make programs to make the lights blink. Nevertheless, many were sold in this form. Roberts was already hard at work on additional cards, including a paper tape reader for storage, additional RAM cards, and a RS-232 interface to connect to a proper terminal.

Related Topics:
Opcode - Paper tape - RAM - RS-232 - Terminal

~ ~ ~ ~ ~ ~ ~ ~ ~ ~